AUTEL MAXIFLASH VCMI

The MaxiFlash VCMI J2534 interface is a Bluetooth-enabled vehicle communication Measurement Interface (VCMI) J2534-1 and J2534-2 compliant pass-thru programming device, includes Built-in 4-Channel Oscilloscope & Digital Volt Ohm Meter and Built-in Waveform Generator & CAN bus tester.
The MaxiFlash VCMI supports CAN FD, 4 CAN Channel, D-PDU, IS O22900-1 & ISO 22900-2 protocols; and is RP1210 compliant. The MaxiFlash VCI can be

Communication Interface (VCI) and J2534 pass-thru programmer;Includes Built-in 4-Channel Oscilloscope & Digital Volt Ohm Meter;Includes Built-in Waveform Generator & CAN bus tester;Wi-Fi/Bluetooth-capable;Supports CAN FD, 4 CAN Channels, and DoIP;Supports D-PDU, IS O22900-1 & ISO 22900-2 and is RP1210 compliant;Use with windows PC for OE programming, J2534-1 & J2534-2 compliant;Program BMW & Mercedes-benz

Used with a Windows computer with an applicable OE subscription for vehicle module programming and Compatible, GM, TOYOTA, BMW, and Mercedes vehicle module programming

Compatibility

Work with MaxiSYS Ultra / Ultra EV, MaxiSYS MS919 / MS919EV

Notice

This is VCI Bluetooth Adapter only for Autel Series Products.
If the VCI Bluetooth Adapter of your device is broken or missed, you can buy a new one to replace it.

Built-In Oscilloscope

The 4 Channel Oscilloscope is faster with 20MHz Bandwidth, more accurate with 80MS/s Sampling Data Rate, and a 32M memory buffer that stores more complex signals, zoom and replay.

Our pre-set Guided Test and Waveform Library instruct technicians on use and fault analysis We also provide a large number of cloud preset cases, including connection diagrams, waveform library, reference waveforms, fault case analysis, and one-press waveform settings.

Built-In Waveform Generator

- The Waveform Generator is used to test a sensor, an actuator, or an ECU without the need to replace them one by one to identify the fault.

- This is done by simulating signals of various sensors and ECUs, and identifying hardware issues.

- Simulates sensor signals to quickly diagnose ECU, sensor, and wiring harness issues;

- Simulates ECU signals to perform active tests to verify functions of certain parts (Electronic fan, solenoid valves, etc);

- Simulates actuator signals and verifies the communication status between the actuator and ECU (Electronic fan, solenoid valve, headlight)

Built-In Multimeter

The professional Multimeter will measure Voltage, Current, Resistance, Diode, Frequency/Period, Duty Cycle, Connectivity, and Pulse Width.

Built-In CAN Bus Check

The CAN Bus Check can quickly determine whether the OBD pins are functioning correctly

CAN FD / DoIP PROTOCOLS

J2534 BRING CAN FD / DoIP/ SAE J2534/ D-PDU/ RP1210 PROTOCOLS

- CAN FD: For MY2020+ FM Models, No Need CAN FD Adapters

- DoIP: For BMW E/ F/ G Chassis, Jaguar, and Land Rover vehicle make.